How to photograph interiors and rooms

9 min read · Updated
How to photograph interiors and rooms
Image: Livioandronico2013, CC BY-SA 4.0 · Wikimedia Commons

Rooms look easy to photograph until you see the results: leaning walls, orange and blue patches of light, burnt-out windows and clutter you did not notice. Good interior photos come from a few repeatable steps. This guide covers lens choice, keeping verticals straight, tripod height, mixed light and white balance, bracketing for bright windows and preparing the room, so your pictures show the space as it feels to stand in it.

Starting points for interiors

SettingTypical value (approximate)Section
Focal length (full frame)About 16–24 mm; avoid the widest end for small rooms1
Camera heightAbout 3–5 ft (chest height), lower for small rooms2
Aperturef/7.1–f/113
ISOBase ISO, on a tripod3
White balanceCustom or a fixed preset, not auto4
Bracketing3–5 frames, 1–2 stops apart5
Timer2-second timer or remote3

1Choose a wide, but not too wide, lens

A wide lens fits more of a room into the frame, but very wide focal lengths stretch the corners and make furniture near the edges look distorted. Many interior photographers work most often around 16–24 mm on full frame (roughly 10–16 mm on a crop sensor, approximate).

How to do it
  • Start around 20–24 mm and widen only as needed.
  • Keep important furniture away from the extreme edges where stretching is strongest.
  • Shoot from a corner or doorway to show two walls and suggest depth.
  • Use the lens's profile correction in editing to remove barrel distortion.

2Keep vertical lines straight

Tilting the camera up or down makes door frames and walls lean. Straight verticals make a room feel calm and professional. The camera height also matters: shooting from about chest height, roughly 3–5 ft (90–150 cm), usually shows furniture tops without looking down on everything (approximate).

Keep vertical lines straight
Image: Markku Haverinen, CC BY 4.0 · Wikimedia Commons
How to do it
  • Level the camera with the built-in level or a hot-shoe level so the sensor is vertical.
  • Adjust height rather than tilting to change what is in the frame.
  • Fix small remaining tilts with vertical perspective correction, leaving margin for the crop.
  • A shift lens moves the view up or down without tilting, if you shoot interiors often.

3Use a tripod and slow down

Interiors are often dim, and you want low ISO for clean shadows and a mid aperture for front-to-back sharpness. That leads to slow shutter speeds, which need a tripod. A tripod also keeps every bracketed frame identical.

How to do it
  • Use base ISO and an aperture around f/7.1–f/11.
  • Let the shutter speed run as long as needed for the exposure.
  • Use a 2-second timer or remote to avoid shake.
  • Focus about a third into the room, or use live view to check near and far sharpness.

4Handle mixed light and white balance

Daylight from windows is bluish, while tungsten and many warm LED bulbs are orange. Auto white balance tries to average them and may change from frame to frame. Colour casts on walls are among the most common interior problems.

How to do it
  • Set a fixed white balance, ideally a custom one measured on a grey card in the main light.
  • Turn off lamps that add strong colour casts, or switch bulbs to a similar colour temperature where possible.
  • Shoot raw so you can fine-tune white balance and local colour later.
  • If you keep lamps on for mood, balance them so they glow rather than dominate.

5Bracket for bright windows

A window can be many stops brighter than the room. One exposure either burns out the view or leaves the room too dark. Bracketing several exposures and blending them, or merging to HDR, keeps both inside and outside detail.

Bracket for bright windows
Image: King of Hearts, CC BY-SA 4.0 · Wikimedia Commons
How to do it
  • Set the camera to bracket 3–5 frames about 1–2 stops apart.
  • Make sure the brightest frame shows good shadow detail and the darkest keeps the window view.
  • Blend in editing, keeping the result natural rather than flat or grey.
  • Shoot on overcast days or when the light outside is softer to reduce the range.

6Tidy up and style the room

The camera sees everything: cables, remote controls, bins, crooked cushions and toothbrushes. Small details are much more visible in a photo than in person. A few minutes of tidying saves a lot of editing.

How to do it
  • Remove personal items, cables and clutter from surfaces.
  • Straighten cushions, curtains, rugs and towels; align chairs.
  • Open blinds evenly and switch on or off lights consistently.
  • Check the screen at full magnification for stray objects before the final shot.

Before you shoot a room

  • Room tidied and styled
  • Lens around 16–24 mm (full frame)
  • Tripod at chest height
  • Camera levelled, verticals straight
  • Base ISO, f/7.1–f/11
  • Fixed white balance, raw on
  • Lamps checked for colour casts
  • Brackets set for windows
  • Timer or remote on

Sources

Related guides