How to photograph reflections (water, puddles, glass)

Reflections double a scene, add symmetry and turn a plain puddle into a window onto the sky. They also behave in ways that surprise beginners: a polariser can remove them, a reflection is focused at a different distance from the water surface, and the slightest breeze breaks the mirror. This guide explains how to find, control and frame reflections in water and glass.
Quick guide
| Situation | What to try (approximate) | Section |
|---|---|---|
| Reflection too weak | Turn the polariser to its weakest setting or remove it | 1 |
| Glare hides what is under the water or glass | Turn the polariser to its strongest setting | 1 |
| Puddle too small to show a scene | Lower the camera to a few inches above the water | 2 |
| Reflection soft, ripples sharp | Focus on the reflected subject, not the surface | 3 |
| Both surface and reflection needed | f/8–f/16 or focus stacking | 3 |
| Wind breaks the mirror | Shoot at dawn or dusk, or use a long exposure | 4 |
| Picture feels unbalanced | Centre the horizon for symmetry, or place it on a third | 5 |
1Use a polariser carefully
Light reflected from water and glass is partly polarised. A circular polarising filter can therefore reduce or remove reflections, which is great for seeing pebbles under a stream but bad if the reflection is your subject. The effect is strongest at roughly 30–40° to the surface and changes as you rotate the filter (approximate).
- Rotate the polariser while looking through the viewfinder or screen and stop where the reflection looks best.
- For mirror-like reflections, set it to its weakest position or take it off.
- To mix both, rotate partway so some reflection remains over visible detail below.
2Get low
The lower the camera, the larger a reflection appears in the frame. A small puddle seen from standing height shows only a patch of sky, but from a few inches above it can hold a whole building. Low angles also lengthen reflections on lakes.

- Hold the camera a few inches above the puddle or use a flip-out screen.
- Turn the camera upside down to bring the lens even closer to the water, then rotate the image later.
- Walk around the puddle until the reflected subject sits where you want it.
3Decide where to focus
A reflection is a virtual image. The reflected subject appears at its own distance behind the surface, so autofocus may pick the water's edge, leaves or ripples while the reflection stays soft, or the other way round.
- For a sharp reflection, focus on the reflected subject itself, or on the real subject if it is in the frame.
- For sharp surface details, such as leaves or raindrops, focus on the surface and let the reflection soften.
- To keep both sharp, use f/8–f/16 or take two frames and blend them (approximate).
4Time it for calm water
Wind is the enemy of mirror reflections. Air is often calmest around sunrise and in the evening, and sheltered bays and small ponds stay smoother than open lakes. Reflections also look strongest when the reflected subject is brightly lit and the water is in shade.
- Check wind forecasts and aim for the early morning.
- Look for sheltered water, and wait for gusts to pass.
- If the surface stays rough, use a long exposure of several seconds with an ND filter to smooth it.
5Compose with symmetry
Reflections invite symmetry. Placing the horizon in the centre creates a calm, mirrored frame, while placing it on a third emphasises either the subject or its reflection. Breaking the mirror deliberately, with a stone or a leaf, can add interest.
- For full symmetry, level the camera carefully and centre the horizon line.
- Use the grid or a level so verticals do not tilt.
- Try a frame with an element that breaks the symmetry, such as a ripple, a duck or a person.
6Glass and windows
Shop windows and glass buildings mix the scene behind you with the scene beyond the glass. Changing your angle and the brightness on each side decides which layer wins.
- Move until the reflected subject overlaps a dark area of the glass, where it shows most clearly.
- Use a polariser to remove unwanted window glare instead.
- Watch for your own reflection; step aside or wear dark clothing.
Before you shoot
- Wind checked, calm time chosen
- Polariser set for the effect you want
- Camera low enough
- Focus set on reflection or surface
- Aperture chosen for depth of field
- Horizon level
- Your own reflection checked