Home › Light & colour

Reflectors and diffusers explained

7 min read · Updated

A reflector bounces existing light back into shadows, while a diffuser sits between the light and the subject to soften it. Together they let you control contrast without extra lamps. Placement matters most: the closer and larger the panel, the stronger and softer its effect on the subject.

Reflectors and diffusers explained
Image: Dmitry Makeev, CC BY-SA 4.0 · Wikimedia Commons

In short

  • Reflectors add light to shadows; diffusers soften and reduce the main light.
  • Silver is strong and crisp, white is soft and natural, gold warms and black subtracts light.
  • Larger and closer panels give softer, stronger effects; distance weakens them quickly.
  • A white wall, foam board or thin white sheet can do the same job for very little money.

What each tool does

A reflector is a light-coloured or shiny surface that redirects light. It does not create light, so it only works when there is a strong source to bounce, such as the sun, a window or a flash.

A diffuser, sometimes called a scrim, is translucent. Placed between the light and the subject, it spreads the light over a larger area, making shadows softer and contrast lower. It also absorbs some light, typically around one stop for common translucent panels (approximate).

The 5-in-1 kit

Many photographers start with a collapsible 5-in-1 reflector: a translucent diffuser disc with a zip-on cover that has silver, white, gold and black sides.

Silver reflects the most and gives crisp, bright fill, useful on overcast days or from a distance. White gives softer, more natural fill. Gold warms skin and can look heavy if overused; mixed silver-gold surfaces are milder. Black is used to subtract light, a technique often called negative fill, to deepen shadows and add shape.

Sizes and shapes

Small round reflectors of about 12–22 in (approximate) suit headshots, products and close-ups and fit in a camera bag. Medium sizes around 32–43 in cover head-and-shoulders portraits. Large rectangular panels and frames of about 4–6 ft can light a full figure or diffuse sun over a small group.

Larger panels catch more wind, so outdoors you may need an assistant, a stand with a sandbag or a clamp. Oval and rectangular shapes are easier to hold and cover a standing person better than round ones.

Placement

Hold a reflector on the shadow side of the subject, angled to catch the main light and send it back. Watch the face as you tilt it; you will see the shadows lift. Moving it closer makes the fill stronger and softer; moving it away weakens it quickly.

A reflector held low, below the face and angled upward, fills eye sockets and adds a catchlight in the lower part of the eyes. Do not place it too low or too strong, or the light will look as if it comes from below.

Hold a diffuser as close to the subject as the frame allows, between the subject and the sun or lamp. Check that its edges are outside the picture and that the background is not now much brighter than the subject.

Outdoor portraits

In harsh midday sun, a diffuser held above the subject turns hard light into soft open-shade light. Expose for the face; the background will often become brighter, so choose a darker background if possible.

With the sun behind the subject, use a white or silver reflector in front to bounce light back into the face. This keeps a glowing rim of light in the hair and a clean exposure on the skin. Ask the subject to look slightly away from a silver reflector if it makes them squint.

DIY options

Foam board or white card, aluminium foil glued to cardboard, a white sheet or a car sun shade can all serve as reflectors. Baking paper, a white shower curtain or thin white fabric make serviceable diffusers.

A white wall or a light-coloured pavement can act as a large natural reflector. Be careful with coloured surfaces such as green grass or red brick, because they tint the bounced light.

Frequently asked questions

Which reflector colour should I start with?

White is the safest choice for natural-looking fill. Use silver when you need more light and gold only when you want a clearly warm look.

Reflector or diffuser at midday?

A diffuser above the subject usually helps more at midday, because it softens the harsh overhead light. A reflector can then add a little fill from below.

How far should a reflector be from the subject?

Start about 2–4 ft away (approximate) and adjust while watching the shadows. Closer gives stronger, softer fill; farther gives a weaker effect.

Do I need an assistant?

It helps, especially with large panels or in wind. Alone, use a stand and clamp, prop the reflector against a bag, or ask the subject to hold a small one out of frame.

Sources

Keep reading