Underwater photography
Underwater, water absorbs red light first, so colours fade with depth and distance. The key is to get close: less water between lens and subject means more colour, contrast and sharpness. Angle strobes outward, away from the lens axis, to reduce backscatter. Dive safety and good buoyancy come first, and never touch or chase marine life.

In short
- Water absorbs red light first, so colours fade with depth and with distance to the subject.
- Get close: less water between lens and subject means more colour, contrast and sharpness.
- Angle strobes outward, away from the lens axis, to reduce backscatter from floating particles.
- Dive safety and good buoyancy come before any photo; never touch or chase marine life.
What makes underwater photography different
Underwater photography covers everything from snorkel snapshots in a rock pool to wide reef scenes and tiny creatures shot on scuba. What unites it is the medium: water is far denser than air, it bends light, it swallows colour and it is full of suspended particles.
The genre has a long history. Louis Boutan took underwater photographs in France in the 1890s and built an early underwater flash. In 1926 William Harding Longley and Charles Martin made the first underwater colour photographs, lit by burning magnesium. Jacques-Yves Cousteau later did much to popularise diving and underwater imaging.
Today a waterproof phone pouch, a compact camera in a housing or a full interchangeable-lens rig can all produce good results, as long as you understand how water changes light.
Why water steals red, and how white balance helps
Water absorbs the long, red wavelengths of light first, then orange and yellow, which is why the sea looks blue. Every foot of water the light travels through, down from the surface and back to your lens, removes more warm colour.
In shallow water with sunlight, a custom white balance can bring much of that colour back. Many cameras let you aim at a white slate or sandy bottom and set white balance manually; redo it whenever your depth changes noticeably. Shooting RAW lets you fine-tune later.
Below roughly 15–30 ft (approximate, it depends on water clarity), there is too little red left to recover with white balance alone. That is where artificial light takes over.
Strobes, video lights and backscatter
A strobe (underwater flash) or a continuous video light puts back the colours water has removed, but only over a short distance, because its light is absorbed too.
Backscatter is the snowstorm of bright dots that appears when light hits particles right in front of the lens. Even clear-looking water is full of them. The fix is geometry: place strobes out to the sides and slightly behind the front of the housing, angled outward, so they light the subject but not the water directly before the lens.
The built-in flash of a compact camera sits next to the lens and causes heavy backscatter; switch it off, or use a diffuser or fibre-optic trigger with an external strobe.
As a rough starting point, try ISO 100–400, f/8 and 1/125 s with strobes, then adjust strobe power rather than aperture to brighten or darken the subject (approximate values).
Get close, then closer
The single most useful rule in underwater photography is to reduce the amount of water between you and the subject. Many experienced shooters aim for a few feet or less.
That is why wide-angle and fisheye lenses are so popular underwater: they let you be very close to a large subject, such as a turtle or a diver, and still fit it in the frame. Macro lenses do the same for tiny subjects.
Shoot slightly upward when you can. A rising angle separates the subject from a busy reef and can place it against open blue water or the bright surface.
Housings, pouches and gear care
A rigid housing made for your exact camera model gives access to most controls and is rated to a stated depth. Check that rating against your planned dives.
Soft phone pouches are cheap and fine for snorkelling or very shallow water, but they are usually rated to modest depths and make buttons harder to press. Test any pouch or housing in a sink or pool without the device inside before trusting it.
Before every dive, inspect and lightly grease the O-ring, keep hair and sand off the seal, and rinse the housing in fresh water afterwards. A small leak alarm is cheap insurance.
Safety and marine life ethics
Dive safety always comes first. Dive within your training and experience, plan the dive with your buddy, and keep watching your depth, air and no-decompression time even while you frame a shot. Photographers are easily absorbed; agree with your buddy how you will stay in contact.
Good buoyancy is the core skill. A camera rig changes your trim, so practise with it in easy conditions before taking it on demanding dives. Hover rather than kneel, and keep fins away from the reef.
Never touch, move, feed or chase animals to get a picture, and do not break or rest on coral. Keep a respectful distance, limit strobe flashes on sensitive or small creatures, and follow local park rules.
Common mistakes and an exercise
Common mistakes include shooting from too far away, aiming down at the reef, pointing strobes straight forward, forgetting to re-set white balance, and letting photography override dive discipline.
Exercise: on one shallow dive or snorkel, choose a single subject that stays put, such as a sea fan or a rock with colourful growth. Shoot it from 6 ft, 3 ft and about 1 ft away, first with natural light and then with strobes. Compare colour and sharpness at home, and note how much difference distance alone makes.
Frequently asked questions
Why do underwater photos look blue or green?
Water absorbs red light first, then orange and yellow, as depth and distance increase. Getting close, using artificial light or setting white balance helps restore colour.
What is backscatter?
It is the bright specks caused when light from a flash or strobe hits particles in the water near the lens. Angling strobes outward and getting closer to the subject reduce it.
Can I take underwater photos with my phone?
Only with a proper waterproof housing rated for your depth, since built-in water resistance is not meant for diving. Stay shallow and close for the best colour.
Is it okay to touch marine life for a photo?
No. Touching, chasing or moving animals and coral can harm them. Good buoyancy control protects both the reef and your photos.