How to photograph waterfalls

Waterfalls are one of the most rewarding subjects for learning shutter speed. The same scene can look frozen and powerful or smooth and soft just by changing the exposure time. This guide covers how to choose that time, how to keep the camera still, how to tame bright light and glare, how to compose the scene and how to stay safe and dry near the water.
Starting settings (approximate)
1Choose the look of the water
Shutter speed decides how moving water looks. A fast speed freezes drops and spray, a moderate one keeps texture with some flow, and a slow one turns the water into smooth streaks.
There is no single correct speed: it depends on how fast the water falls and how close you are. Very long exposures can make water look like fog and lose its shape.
- Start at about 1/4 s and take a test frame.
- Go slower for more smoothness, faster if the water looks like formless mist.
- Try one frozen frame at 1/1000 s or so for contrast.
2Keep the camera still
Any exposure slower than about 1/30 s needs support (approximate). Rocks are slippery and water flow can vibrate a tripod standing in a stream.
- Use a tripod and spread the legs on firm rocks, not in fast water.
- Use a 2-second timer or remote release.
- Turn off stabilisation on a tripod if your lens or camera recommends it.
- Weigh the tripod down with your bag in wind.
3Set the exposure
To get a slow speed in daylight, lower ISO and use a moderate aperture. Stopping down further than about f/11 on full frame adds diffraction softness, so use filters rather than tiny apertures for very slow speeds.
White water is easy to overexpose. Check the histogram and the highlight warning.

- Use manual or aperture priority at base ISO and around f/8–f/11.
- Watch the highlights; reduce exposure if the water clips.
- Bracket two or three exposures if the scene has deep shade and bright water.
4Use filters
A neutral density (ND) filter cuts light evenly so you can use slower speeds in daylight. A polarising filter removes glare from wet rocks and leaves and also cuts about one to two stops of light (approximate).
- Fit the polariser and rotate it while watching the glare on rocks disappear.
- Add a 3–6 stop ND filter if the speed is still too fast.
- Recheck focus and exposure after adding filters.
5Pick the right light
Bright sun creates harsh contrast between white water and dark shade. Overcast days, shade and the hour after sunrise or before sunset give soft, even light and slower speeds naturally.
- Go on cloudy days or when the falls are fully in shade.
- Avoid patchy sun that puts half the falls in light.
- Set white balance by eye; shade can turn the scene blue.
6Compose the scene
Waterfalls often look better with a foreground: rocks, moss, a stream leading towards the falls or a person for scale. Wide lenses show the setting; longer lenses isolate patterns in the water.
- Look for a stream or rocks that lead the eye to the falls.
- Include a small element for scale.
- Try a longer focal length for details of falling water.
7Stay safe and dry
Spray coats the lens quickly and wet rocks are dangerous. No photo is worth a fall or entering closed areas.
- Stay on paths and away from edges; obey signs.
- Carry a microfibre cloth and check the front element between frames.
- Use a lens hood and keep the camera covered between shots.
- Wear shoes with good grip.
Before you shoot
- Tripod set on firm rock
- Timer or remote on
- Base ISO and f/8–f/11
- Shutter speed chosen for the look
- Polariser rotated for glare
- ND filter if needed
- Highlights checked
- Lens wiped of spray