Home › Optics & camera tech

Image stabilisation explained

7 min read · Updated

Image stabilisation moves a lens element or the sensor to cancel small hand movements, letting you use slower shutter speeds handheld. It reduces camera shake but not subject motion. A common starting point is a shutter speed of about 1/focal length, then slower with stabilisation.

Image stabilisation explained
Image: Curtis Palmer, CC BY 2.0 · Wikimedia Commons

In short

  • Stabilisation fights camera shake, not a moving subject.
  • Lens systems shift an optical group; in-body systems move the sensor.
  • The reciprocal rule, about 1/focal length, is a rough handheld starting point.
  • On a solid tripod, many systems work best switched off unless the manual says otherwise.

What stabilisation does

When you hold a camera, tiny movements from breathing and heartbeat shake the image during the exposure. At fast shutter speeds this does not show, but at slow speeds it blurs fine detail.

Stabilisation detects this movement with motion sensors and moves something inside the camera or lens in the opposite direction, so the image stays still on the sensor.

Lens versus sensor stabilisation

Lens-based stabilisation moves a group of glass elements. It is tuned to the specific lens and is especially effective with long telephoto lenses, and the viewfinder image is steadied as well on many cameras.

In-body (sensor-shift) stabilisation moves the sensor itself, so it works with almost any lens, including older and adapted ones. Many current systems combine both and coordinate them for extra benefit.

How much it helps

Makers rate stabilisation in stops, measured under standard test conditions. Real-world gains vary with technique, focal length and the person holding the camera, so think of a rating as an upper limit rather than a promise.

As a rough example, a 3-stop gain could turn a safe 1/200 s into about 1/25 s. Shoot several frames at slow speeds; some will be sharper than others.

The reciprocal rule

A long-standing rule of thumb says the slowest safe handheld speed is about one over the focal length: 1/50 s at 50 mm, 1/200 s at 200 mm. On a crop sensor, use the equivalent focal length. With high-resolution sensors, many people choose a speed about twice as fast (approximate).

Good technique also helps: brace your elbows, exhale gently, press the shutter softly, lean on a wall or use burst mode.

What it cannot do

Stabilisation does nothing for a moving subject. A child running at 1/15 s will be blurred however steady your hands are. For movement, you need a faster shutter speed, which may mean a wider aperture or higher ISO.

Some lenses offer a panning mode that stabilises only one direction, which helps when you follow a moving subject sideways.

When to turn it off

On a firm tripod, some stabilisers can create small movements as they search for shake that is not there. Many manuals recommend switching it off on a tripod, though some newer systems detect the tripod automatically. Check your manual.

Also consider switching it off for very fast shutter speeds where it adds little, and for long exposures of the night sky on a tripod.

Frequently asked questions

Is lens stabilisation better than in-body stabilisation?

Neither is simply better. Lens systems often excel with long telephotos; in-body systems help every lens. Combined systems usually give the largest gain.

Can stabilisation replace a tripod?

For short handheld exposures, often yes. For long exposures of several seconds, panoramas or precise framing, a tripod is still needed.

Does stabilisation affect battery life?

Slightly, because motors and sensors run while it is active. The effect is usually small.

Why are my photos still blurry with stabilisation?

Either the subject moved, the speed was too slow even with stabilisation, or focus missed. Check whether everything is blurred (shake) or only the subject (motion).

Sources

Keep reading